Neck position SD P Rail wiring question/s

Explorerlover

My plan is to use the p Rail in the neck position of my explorer along with a bridge pickup which is still to be decided on. I checked out the wiring diagram http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=2_prails_1v_1t_3w_mini on the Seymour Duncan website, but the 3 way mini toggle switch confuses me as I'm not using two of te same pup. So my questions are as follows:

1. If I was to use another humbucker in the bridge position, would I be able to still get all 3 the P Rail's voicings by using a 3 way mini toggle with only the P rail?
2. How would I hook up the wires from the P Rail to the mini toggle?
3. By removing the bridge pup from the SD schematic, how would the wiring diagram look if the bridge P Rail was replaced by another "normal" humbucker.?

Thanks

AlanRatcliffe

Simply remove the second P-Rail's wires from the switch (leave the extra earth wire to the back of the pot though). The normal humbucker wires directly to the big 3-way toggle, bypassing the mini toggle completely.

The switch pictured would still work, but you could also use a single pole three way switch (with only three lugs) if you wanted.

Explorerlover

Thanks Alan....Just wanted to make sure before I take off with the soldering iron.