Skywalker
Howzit all 8)
Just a quick Q for the technically minded.
I'm re-buliding my pedal board AGAIN :? and will be incorporating my recently aquired Line 6 G30 wireless system (thanks MR T 8)).
Here's the thing though. Do I HAVE to use the line 6 power supply that comes with it or can i run it off my CIOKS DC-10 power supply? I'm pretty sure that the CIOKS will be able to power it as I'm not running a helluva lot off it with pedals etc. but is it advisable to use something other than the Line 6 power supply? The G30 supply is rated at 9.6VDC and 200mA. All I'll have in the setup is my Bad Horsie wah, TU2 tuner,NS2,CH1 chorus,DD20 delay and GE7 eq.
I basically just want to save some space and not have a million cables etc all over the place :?
Mr-M
You can run it off your CIOKS just fine. Use it on a 9V output with at least 200ma available. I used my BBE Supacharger, which is not as good a supply as your DC10, and it worked perfectly. The fact that you can use a typical pedal power supply is one of the main selling points of the G30 over other wireless units.
Dinosaur-Snr
+1 to what Mr T said, and if it doesn't work then you can let us know. ? lol
Skywalker
Ausum.
Thanks guys. Just wanted to make sure before I fried something.
I'll hook it up later.
Rock n Roll 8)
matta
Just check the polarity of the Line6 and make sure it matches the Cioks cable!
Skywalker
Will check that out aswell.
Thanks Matta 8)
Mr-M
The polarity is negative center.
